Charging mobile phone using bluetooth

A Review Paper on Wireless charging of mobile phones

Total Downloads : 6

Authors : Ashwini Jayawant, Swati Zope

Paper ID : IJERTCONV2IS04044

Volume & Issue :ICONET – 2014 (Volume 2 – Issue 04)

Published (First Online): 30-07-2018

ISSN (Online) : 2278-0181

Publisher Name : IJERT

License: This work is licensed under a Creative Commons Attribution 4.0 International License

A Review Paper on Wireless charging of mobile phones

Ashwini Jayawant1, Swati Zope2

Assistant professor, K.C.College of Engineering & Management studies & Research Mumbai University, India

Nowadays Mobile communication not only restricted for voice transmission but also used for various multimedia applications like transfer of text, images, videos, playing games etc. Continuous use of mobile phones needs charging of the batteries again and again. Imagine a system where your cellular phone battery is always charged, You dont have to worry if you forget the charger. In this paper two methods are studied first is wireless charging of mobile phones using microwaves which eliminates the need of separate charger for mobiles .In this method the charging of mobile phones is done using microwaves when we talk on that particular mobile .The microwave frequency used is 2.45Ghz.The second method is charging of mobile phones using Bluetooth.

Keywords Mobile communication, microwave, wireless charging

1. Introduction There is an abundance of energy around us at all times. Radio and television towers, the cellular phone antennas, and even satellites orbiting earth are constantly transmitting energy. It will be very useful if we gather the energy and store it and use it as a source of power for other circuits. In the case of the cellular phone, this power could be used to recharge a battery that is constantly being depleted. The first step is to capture the energy from air and second step needs an efficient antenna which will convert AC to DC. [1]
   1. Wireless charging of mobile phones using microwaves [2] Microwaves are a form of electromagnetic radiation with wavelengths ranging from as long as one meter to as short as one millimetre, or equivalently, with frequencies between 300 MHz (0.3 GHz) and 300 GHz. There are various advantages of microwave over low frequencies such as
      • Directivity: As frequency increases the directivity increase and beam width reduces.
      • More bandwidth at higher frequencies.
      • Microwave signals travel by line of sight and are capable of freely propagating through snow, clouds and smoke therefore used for communication. [3]
   2. Wireless power transmission Figure 1. Block diagram of Wireless power transmission The block diagram consists of microwave generator which actually produces microwave and microwave convertor which will convert microwave energy into dc power
      1. Microwave generator. Magnetron is used to generate microwave at preferred frequency; basically the magnetron is a high- powered vacuum tube that works as self-excited microwave oscillator. To produce high power output crossed electronic and magnetic fields are used. A circulator is a passive device which has three or four ports in which a radiofrequency or microwave signal entering any port is transmitted to the next port in rotation. A port in this context is a point where an external transmission line or waveguide connects to the device. For a circulator which has four ports, a signal applied to port 1 only comes out of port 2; a signal applied to port 2 only comes out of port 3; a signal applied to port 3 only comes out of port 1. Tuner is used for impedance matching with transmitting antenna. The transmitting antenna can be a patch antenna and is fabricated from copper plating that is soldered to a feed wire and has a ground plane. We can use slotted waveguide antenna for the same purpose.
      2. Microwave convertor: Rectenna is used to convert microwave energy into dc power. A simple rectenna element consists of a dipole antenna with an RF diode connected across the dipole elements. The diode rectifies the AC current induced in the antenna by the microwaves. Schottky diodes are used for production of DC power, which powers a load connected across the diode. Schottky diodes are usually used because they have the lowest voltage drop, highest speed and low noise index which is important for communication receivers. Rectenna is key component in wireless power transmission because the capacity of the utility power at the receiving site depends on the rectenna performance. Figure 2. Block diagram of convertor system Antenna shown here is rectangular microstrip patch antenna (RMPA).Rectification process converts ac to dc. Low pass filter is used to remove the harmonics which are generated during rectification process it is necessary to remove the harmonics as they are radiated back through antenna thus resulting in significant loss of energy. To suppress re-radiation and to maximize the power conversion, Low pass filter is placed between antenna and rectifier setup. The cut-off frequency for Low Pass Filter has been selected such that second harmonic signals are rejected. [4].The use of matching network is impedance matching of input impedance of low pass filter and antenna so that maximum power will be transmitted. After this match circuit the rectifying diode is placed for rectification followed by DC pass filter which consists of smoothing capacitor for reducing ripples also followed by load. The conversion efficiency depends on this DC pass filter set up i.e. value and position of dc pass filter setup.
      3. Frequency to voltage convertor. A signal is sent when user is talking this is very important as phone has to be charged as long as user is talking. The frequency to voltage convertor would act as switch to turn rectenna circuit ON when user starts his conversation signal is sent to sensor circuit. LM 2907 can be used as a sensor to convert frequency to voltage. Thus on reception of the signal sensor circuit switches rectenna circuit ON and mobile phone begins to charge.
      • Radiation problem may accure.
      • Network traffic may cause problem in charging.
      • Rectenna circuit makes device bulky.
      • Wireless charging increases heat in device as compare to wired method.

      Bluetooth is a wireless technology standard for exchanging data over short distance using short wavelength microwave transmission in the ism band from (2400-2800) MHz, from fixed and mobile devices. The table shows different classes of Bluetooth based on maximum power it can transmit.

      Table 1 Different classes of Bluetooth

      Bluetooth can act as transmitter as well as receiver. Thus Bluetooth device can be used for wireless charging of mobiles. Transmitter is one Bluetooth device which will transmit RF signals of different power depending upon its class. Receiver will be another Bluetooth device and from received signal

      maximum energy will be extracted using following voltage doubler circuit.

      Figure 3 Voltage doubler circuit

      A voltage doubler is an electronic circuit which charges capacitrs from the input voltage and switches these charges in such a way that, in the ideal case, exactly twice the voltage is produced at the output as at its input. The simplest of these circuits are a form

      of rectifier which take an AC voltage as input and output a doubled DC voltage. The output of this circuit is used to charge the mobile batteries.

      This method can be use to charge the mobile phones in case of emergency, as the circuit size is small it can be easily implemented inside the mobile phones.

      In this paper two methods for wireless charging of mobile phones are studied. Charging of mobile phones can be done using microwaves and Bluetooth. These methods eliminate need of separate charger thus making the use of mobiles possible in case of emergency even if charger is not available. These methods also results in harvesting of energy.

      1. A Highly Efficient Power Management System for Charging Mobile Phones using RF Energy Harvesting/ Ajay Sivaramakrishnan , Kailarajan Jeyaprakash Jegadishkumar/ International Journal of Information Technology Convergence and Services (IJITCS) Vol.1, No.5, October 2011
      2. 2-GHz Rectenna For Wireless PowerTransmission/ Shailendra Singh Ojha, P.K. Singhal/Current Research in Engineering, Science and Technology (CREST) Journals [ ISSN 2320-706X ]Vol 01 | Issue 01 | March 2013 | 24-29
      3. Wireless Power Transmission A Next Generation Power Transmission System, International Journal of Computer Applications (0975 8887) Volume 1 No. 13
      4. W. Geyi, P Jarmuszewski, and Y. Qi, «The foster reactancetheorem for antennas and radiation q,» Antennas and Propagation, IEEE Transactions on, vol. 48, no. 3, pp. 401-408, Mar 2000.
      5. J. S. Mclean, «A re-examination of the fundamental limits on the radiation q of electrically

      small antennas,» Antennas and Propagation, IEEE Transactions on, vol. 44, no. 5, pp. 672-,

      [10]T. Ungan and L. Reindl, «Harvesting low ambient rf- sources for autonomous measurement

      systems, » Instrumentation and Measurement Technology Conference Proceedings, 2008.

      IMTC2008. IEEE, pp. 6265, May 2008

      [11]Hagerty, F. Helmbrecht, W. McCalpin, R. Zane, and Z. Popovic,

      «Recycling ambient microwave energy with broad-band rectenna arrays,» Microwave Theory and

      Techniques, IEEETransactions on, vol. 52, no. 3, pp. 1014-

      1. Wireless battery charging system using radio frequency energy harvesting /Danial W.Harrist/BS University of pitussburg/2001
      2. Wireless charging of mobile phones using microwaves / Dimple,Divanshi sing/International journal of electrical and electronics engineers,IJEEE/2012
      3. Microwave and RADAR engineering./K.K.Sharma
      4. 2-GHz Rectenna For Wireless PowerTransmission/ Shailendra Singh Ojha, P.K. Singhal/Current Research in Engineering, Science and Technology (CREST) Journals [ ISSN 2320-706X ]Vol 01 | Issue 01 | March 2013 | 24-29

      Источник

      Charging mobile phone using bluetooth

      

      

      Can i charge a phone on a laptop via bluetooth?

      My charger will not work, and I wanted to know how to charge my phone using bluetooth.

      Can you help us by answering one of these related questions?

      We need your help! Please help us improve our content by removing questions that are essentially the same and merging them into this question. Please tell us which questions below are the same as this one:

      Leader Board What’s this?

      Leading Today			Pts	Helpful
      1.	leroychar	200	100%
      2.	Khalel	200	75%
      3.	StreetSma	200	70%
      4.	mindsetfr	200	91%
      5.	shadowgho	200	84%
      6.	abaterb	200	100%
      7.	aeejeey_o	200	98%
      8.	jennifer.	200	68%
      9.	bipu%u266	200	100%
      10.	handyfrit	200	75%
      11.	Amitkumar	200	100%
      12.	Me-zha	200	80%
      13.	kentnico3	0	69%
      14.	lanz08	0	64%
      15.	Manan Son	0	94%
      Leading this Week			Pts	Helpful
      1.	kfa13	400	72%
      2.	lorily7	400	64%
      3.	jennifer.	400	68%
      4.	buslangan	200	100%
      5.	aeejeey_o	200	98%
      6.	anveshmit	200	67%
      7.	MadamCara	200	85%
      8.	jyotsana_	200	100%
      9.	Millerram	200	100%
      10.	brege17	200	80%
      11.	FIEDIM	200	88%
      12.	handyfrit	200	75%
      13.	Salman Sh	200	67%
      14.	Reset1332	200	100%
      15.	gagandeep	200	100%
      16.	user20005	200	90%
      17.	leroychar	200	100%
      18.	Me-zha	200	80%
      19.	https://w	200	63%
      20.	https://w	200	82%
      Leading this Month			Pts	Helpful
      1.	jennifer.	600	68%
      2.	Atray3	600	96%
      3.	Mubeshr	600	100%
      4.	mindsetfr	400	91%
      5.	user20005	400	90%
      6.	jdelacruz	400	85%
      7.	sup3rmike	400	72%
      8.	Marjhone	400	63%
      9.	nazenborg	400	82%
      10.	Me-zha	400	80%
      11.	awesomete	400	95%
      12.	KristaNeu	400	61%
      13.	Emerypont	223	100%
      14.	Millerram	217	100%
      15.	MIKELLO	202	67%
      16.	elitehear	200	62%
      17.	HarrisonG	200	100%
      18.	chanus	200	68%
      19.	Noorul Ha	200	100%
      20.	chealday	200	72%
      21.	matlalams	200	97%
      22.	Rexdeocam	200	100%
      23.	ayankafra	200	100%
      24.	kofieric	200	100%
      25.	hemagupta	200	100%

      

      ABOUT US

      

      Q’S & A’S

      

      ASKMEFAST ON FACEBOOK

      Like us to stay up to date
      with the AskMeFast community and
      connect with other members.

      

      LATEST ACTIVITY

      Источник

      Читайте также:  Наушники накладные bluetooth sony wh ch710n black