Dd wrt linux commands
If you have flashed your router with DD-WRT or Tomato you can probably use the following linux commands in the picture below.
Before you get started, you’ll need to enable Telnet client on your Windows computer. Go to Programs and Features under the Control Panel. Telnet client is found under add/remove features.
If you want to capture the information to a local Windows computer, during the telnet session, make a folder on your C: drive named telnet. Then type :
telnet youripaddress -f c:\telnet\capture.txt
Enter your username and password.
Want to see the commands that are available? Type ls /*bin /*/*bin . – ls will list the commands and used with bin will give the commands found in the different directories that have ‘bin’ in the name.
While there are hundreds of command options for both operating systems, they are primarily Linux.
Here’s a great list – link. (Not all commands will work)
uname -a gives the Linux version
Want to see a ton of information about your router? Type sysinfo | more
This will give you information about the system including CPU, memory, network and a ton of other information.
unknown login: root
Password:
Tomato v1.28.0000 MIPSR2-120 K26 Max
========================================================
Welcome to the Linksys E2000 [TomatoUSB]
Uptime: 00:39:53 up 1:54
Load average: 0.16, 0.03, 0.01
Mem usage: 30.8% (used 8.88 of 28.84 MB)
WAN : 192.168.0.3/24 @ C0:C1:C0:xx:xx:xx
LAN : 192.168.1.1/24 @ DHCP: 192.168.1.2 – 192.168.1.51
WL0 : Zeus @ channel: 6 @ C0:C1:C0:xx:xx:xx
========================================================
root@unknown:/tmp/home/root# ls /*bin
/bin:
ash date fgrep ls netstat ping sed udpxy
busybox dd grep mdu nice ping6 sh umount
cat df gunzip mkdir ntpc ps sleep uname
chmod dmesg gzip mknod ntpstep pwd stty usleep
chown eapd kill more ntpsync rm sync vi
cp echo ln mount nvram rmdir tar watch
cstats egrep login mv pidof rstats touch zcat
/sbin:
arp hotplug mtd-erase sched
buttons hotplug2 mtd-unlock service
console ifconfig mtd-write setconsole
ddns-update init ppp_event syslogd
dhcp6c-state insmod radio udevtrigger
dhcpc-event klogd rc udhcpc
dhcpc-release led rcheck vconfig
dhcpc-renew listen reboot wldist
disconnected_pppoe lsmod redial
gpio modprobe rmmod
halt mount-cifs route
root@unknown:/tmp/home/root# sysinfo
Tomato v1.28.0000 MIPSR2-120 K26 Max
Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #37 Sat Jun 7 05:30:28
CEST 2014
NVRAM
1012 entries, 21604 bytes used, 39836 bytes free.
INTERFACES
br0 Link encap:Ethernet HWaddr C0:C1:C0:xx:xx:xx
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:185075 errors:0 dropped:0 overruns:0 frame:0
TX packets:166658 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:21559405 (20.5 MiB) TX bytes:160278768 (152.8 MiB)
eth0 Link encap:Ethernet HWaddr C0:C1:C0xx:xx:xx
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:165763 errors:0 dropped:0 overruns:0 frame:0
TX packets:175648 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:161724476 (154.2 MiB) TX bytes:22794209 (21.7 MiB)
Interrupt:4 Base address:0x2000
eth1 Link encap:Ethernet HWaddr C0:C1:C0:xx:xx:xx
UP BROADCAST RUNNING ALLMULTI MULTICAST MTU:1500 Metric:1
RX packets:235085 errors:10 dropped:0 overruns:0 frame:269509
TX packets:234875 errors:72 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:56724666 (54.0 MiB) TX bytes:201731456 (192.3 MiB)
Interrupt:3 Base address:0x1000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MULTICAST MTU:16436 Metric:1
RX packets:87 errors:0 dropped:0 overruns:0 frame:0
TX packets:87 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:13018 (12.7 KiB) TX bytes:13018 (12.7 KiB)
vlan1 Link encap:Ethernet HWaddr C0:C1:C0:xx:xx:xx
UP BROADCAST RUNNING ALLMULTI MULTICAST MTU:1500 Metric:1
RX packets:7418 errors:0 dropped:0 overruns:0 frame:0
TX packets:16101 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:5137752 (4.8 MiB) TX bytes:1536952 (1.4 MiB)
vlan2 Link encap:Ethernet HWaddr C0:C1:C0xx:xx:xx
inet addr:192.168.0.3 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:158047 errors:0 dropped:0 overruns:0 frame:0
TX packets:159142 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:153556156 (146.4 MiB) TX bytes:21209557 (20.2 MiB)
ROUTING TABLE
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.1 0.0.0.0 255.255.255.255 UH 0 0 0 vlan2
192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 br0
192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 vlan2
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 vlan2
Kernel IPv6 routing table
Destination Next Hop
Flags Metric Ref Use Iface
::1/128 ::
U 0 0 1 lo
ARP TABLE
192.168.0.1 dev vlan2 lladdr 00:09:5b:cd:50:40 REACHABLE
192.168.1.38 dev br0 lladdr 68:5d:43:e7:83:44 REACHABLE
IP TABLES
:filter
Chain INPUT (policy DROP 403 packets, 193K bytes)
pkts bytes target prot opt in out source destination
692 61801 DROP all — * * 0.0.0.0/0 0.0.0.0/0
state INVALID
10214 1655K ACCEPT all — * * 0.0.0.0/0 0.0.0.0/0
state RELATED,ESTABLISHED
0 0 shlimit tcp — * * 0.0.0.0/0 0.0.0.0/0
tcp dpt:22 state NEW
14 2052 ACCEPT all — lo * 0.0.0.0/0 0.0.0.0/0
6522 793K ACCEPT all — br0 * 0.0.0.0/0 0.0.0.0/0
0 0 ACCEPT udp — * * 0.0.0.0/0 0.0.0.0/0
udp spt:67 dpt:68
Chain FORWARD (policy DROP 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
253K 139M all — * * 0.0.0.0/0 0.0.0.0/0
account: network/netmask: 192.168.1.0/255.255.255.0 name: lan
0 0 ACCEPT all — br0 br0 0.0.0.0/0 0.0.0.0/0
59 2360 DROP all — * * 0.0.0.0/0 0.0.0.0/0
state INVALID
9434 453K TCPMSS tcp — * * 0.0.0.0/0 0.0.0.0/0
tcp flags:0x06/0x02 TCPMSS clamp to PMTU
128K 15M monitor all — * vlan2 0.0.0.0/0 0.0.0.0/0
249K 138M ACCEPT all — * * 0.0.0.0/0 0.0.0.0/0
state RELATED,ESTABLISHED
0 0 wanin all — vlan2 * 0.0.0.0/0 0.0.0.0/0
4738 223K wanout all — * vlan2 0.0.0.0/0 0.0.0.0/0
4738 223K ACCEPT all — br0 * 0.0.0.0/0 0.0.0.0/0
Chain OUTPUT (policy ACCEPT 12586 packets, 5087K bytes)
pkts bytes target prot opt in out source destination
Chain monitor (1 references)
pkts bytes target prot opt in out source destination
0 0 RETURN tcp — * * 0.0.0.0/0 0.0.0.0/0
WEBMON –max_domains 2000 –max_searches 2000
Chain shlimit (1 references)
pkts bytes target prot opt in out source destination
0 0 all — * * 0.0.0.0/0 0.0.0.0/0
recent: SET name: shlimit side: source
0 0 DROP all — * * 0.0.0.0/0 0.0.0.0/0
recent: UPDATE seconds: 60 hit_count: 4 name: shlimit side: source
Chain wanin (1 references)
pkts bytes target prot opt in out source destination
Chain wanout (1 references)
pkts bytes target prot opt in out source destination
:nat
Chain PREROUTING (policy ACCEPT 9977 packets, 1113K bytes)
pkts bytes target prot opt in out source destination
403 193K WANPREROUTING all — * * 0.0.0.0/0 192.168.
0.3
0 0 DROP all — vlan2 * 0.0.0.0/0 192.168.1.0/
24
Chain POSTROUTING (policy ACCEPT 10 packets, 1912 bytes)
pkts bytes target prot opt in out source destination
6165 323K MASQUERADE all — * vlan2 0.0.0.0/0 0.0.0.0/0
26 8531 SNAT all — * br0 192.168.1.0/24 192.168.1.0/
24 to:192.168.1.1
Chain OUTPUT (policy ACCEPT 1812 packets, 127K bytes)
pkts bytes target prot opt in out source destination
Chain WANPREROUTING (1 references)
pkts bytes target prot opt in out source destination
0 0 DNAT icmp — * * 0.0.0.0/0 0.0.0.0/0
to:192.168.1.1
:mangle
Chain PREROUTING (policy ACCEPT 273K packets, 142M bytes)
pkts bytes target prot opt in out source destination
128K 124M DSCP all — vlan2 * 0.0.0.0/0 0.0.0.0/0
DSCP set 0x00
Chain INPUT (policy ACCEPT 17877 packets, 2707K bytes)
pkts bytes target prot opt in out source destination
Chain FORWARD (policy ACCEPT 253K packets, 139M bytes)
pkts bytes target prot opt in out source destination
Chain OUTPUT (policy ACCEPT 12618 packets, 5092K bytes)
pkts bytes target prot opt in out source destination
Chain POSTROUTING (policy ACCEPT 266K packets, 144M bytes)
pkts bytes target prot opt in out source destination
IP6 TABLES
:filter
Chain INPUT (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
:mangle
Chain PREROUTING (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain INPUT (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain FORWARD (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
Chain POSTROUTING (policy ACCEPT 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination