Saved searches
Use saved searches to filter your results more quickly
You signed in with another tab or window. Reload to refresh your session. You signed out in another tab or window. Reload to refresh your session. You switched accounts on another tab or window. Reload to refresh your session.
Releases: Duet3D/RepRapFirmware
Release 3.4.6-rc.1
Release 3.5.0-beta.4
This release fixes bugs in beta 3 and brings a few new features:
- LED strips on expansion boards
- Experimental Enterprise Authentication to WiFi-equipped Duets.
- Reduced motor noise and an experimental Assisted Open Loop mode for the Expansion 1HCL board
Duet users running in standalone mode can use the files here. The WiFi server modules are still version 2.1-beta4 so there is no need to reinstall them if you are already using that version.
Duet users running in SBC mode should upgrade from the unstable feed on the package server as usual.
Release 3.5.0-beta.3
This release brings input shaping to CAN-connected expansion boards, pressure advance synchronised to input shaping, some minor feature improvements and bug fixes. Release notes are at https://github.com/Duet3D/RepRapFirmware/wiki/Changelog-RRF-3.x-Beta#reprapfirmware-350beta3.
Release 3.5.0beta2
This beta release brings a number of new features and bug fixes. See https://github.com/Duet3D/RepRapFirmware/wiki/Changelog-RRF-3.x-Beta#reprapfirmware-350beta2 for the change list.
Users of Duets in SBC mode should update from the package server. User of Duet in standalone mode should use the files here. The WiFi files are from WiFiSocketServerRTOS release 2.1beta3.
Release 3.5beta1
This release brings support for dual motion systems on some boards, more types of user input in M291 message box commands, array-values variables, and many smaller improvements to functionality. Be sure to read the upgrade notes and known issues list at https://github.com/Duet3D/RepRapFirmware/wiki/Changelog-RRF-3.x-Beta#reprapfirmware-350-beta1 before upgrading! As this is the first beta following major changes to the motion system planning code, it is not recommended for those of a nervous disposition. You may wish to test at reduced motor currents initially.
- CAN protocols have not changed significantly in this release, so version 3.5beta1 main board firmware will work with version 3.4.x expansion board firmware, and vice versa.
- For WiFi enabled boards, DuetWiFiServer version 2.1beta 2 is included with these files; however you can continue using version 1.27 if you wish. In some systems, version 2.1beta2 may give a lower upload speed than 1.27, however it supports additional features such as WiFi scanning and WPA Enterprise (details to follow) and it may work better with some WiFi access points than 1.27 does. Note, if you do upgrade to 2.1beta2 then you will have to re-enter your access point details using M587.