Обновление ПО RMC2 RMC_EU_K16158 (8X0906961T). Audi Q3
Прежде чем начинать какие-либо работы, нужно определиться с тем, что же у вас установлено.
Есть несколько вариантов:
— если у вас установлена магнитола без складывающегося экрана, пример на фото ниже, то у вас » Chorus » и стоит почитать труды других людей по установке хотя бы RMC.
— если у вас в информации о системе ( Menu → Setup MMI ) написано » RMC «, пример на фото ниже, то вам сюда
— если у вас написано что-то вроде картинки ниже, то вам повезло и у вас » MMI «, добро пожаловать вот в эту тему на форуме audi-club
Теперь нужно понять какое RMC у вас установлено. Для этого читаем информацию с помощью шнурка VCDS и смотрим в тему Максима по видам RMC, там все детально расписано. Кто не дочитает до конца, то на рестайл/фейслифт идет RMC4 , и вам нужно искать свое обновление, например, вот .
У меня установлена голова 8U0035183 (8U0 035 183). У меня Дорестайл и RMC2 .
И, наконец, вышло обновление RMC2 RMC_EU_K16158 8X0906961T (8X0 906 961 T). Версия BT 3.70.4. Поэтому обновляемся.
В этой статье я расскажу как это сделать.
Для начала еще раз убедимся в том, какая версия у нас установлена:
— Посмотреть в Menu → Setup MMI . Будет примерно такая картина
— Либо в скрытом меню для RMC (как активировать читать тут Активация скрытого и инженерного меню для RMC Concert или вот тут ). Чтобы попасть в скрытое меню, нужно нажать одновременно кнопки TONE и CAR. Будет примерно такая картина
Далее, когда проверили свою версию, начинаем подготовку к обновлению. Нам понадобится:
— SD-карта, отформатированная в FAT32
— Архив с обновлением, ссылка
Скачиваем архив себе на компьютер, и разархивируем содержимое архива на SD-карту.
Далее вставляем карту в магнитолу, проверяем, что она определилась (нужно зайти в Media на магнитоле, но проигрывать там, конечно, будет нечего). Далее приступаем к обновлению.
Если вы попробуете зайти Menu→Setup MMI и обновиться, то обновите лишь Bluetooth компонент.
Для обновления программного обеспечения всей головы, необходимо зайти в инженерное меню (если забыли, то оно изначально не активировано, и я вот тут расписываю активацию).
Чтобы попасть в инженерное меню, нужно нажать кнопки » Back » и » Car » одновременно.
Попадаем в него и видим вот такую картину:
Q3 Can’t connect to Bluetooth in my car
Hello.
My Car : AUDI Q3 , 2014 , 4X4 , 2.0T
MULYIMEDIA : 8u0-035-183C
SOFTWARE VERSION : RMC_EU_P12321
I bought a firmware update
RMC_EU_K16158
For my multimedia from the site> upgrademyaudi.net
After a few minutes when I finish updating the firmware, I receive a message that the update was unsuccessful
I am attaching the video here for my Bluetooth issue
My phone can’t find Bluetooth
I also tried IPHONE ANDORID too
The problem is not on the phone
Can anyone help me (explain to me) how to solve the problem?
cosmicblue
Registered User
One doesn’t ‘buy’ firmware updates as they are supplied, electronically, by Audi in Germany to an Audi dealer. This isn’t a money-making scam but rather a reflection of the myriad of software inter-dependencies that each car has dependent on the options that were factory installed. You have most likely trashed MMI.
Stolen 27/6/2023 — 2020 RSQ3 Std, Daytona Grey
Gone, RSQ3 Performance, Ascari Blue
Gone, 2018 B9 RS4. Misano Red
Gone 2015 RSQ3, Sepang Blue
.
pronati
Registered User
One doesn’t ‘buy’ firmware updates as they are supplied, electronically, by Audi in Germany to an Audi dealer. This isn’t a money-making scam but rather a reflection of the myriad of software inter-dependencies that each car has dependent on the options that were factory installed. You have most likely trashed MMI.
OK
I think I will replace another MMI unit
To make the right choice
Would you recommend me to buy an MMI unit with the exact same part number? (8u0-035-183C)
I found on EBAY similar part numbers
Like: 8U0-035-183A
Which part number is best for my car?
R1 van
Registered User
I have just looked into this download as to update the software/firmware. (RMC_EU_P11474) TO (RMC_EU_K16158)
To try to fix the quality of the phone call as the person receiving the call cannot hear the person in the car. (microphone has been replaced)
I’ve been told that the software update could fix the fault ??
Also ours does the same sometimes with the bluetooth connection the same as in your video. But then on other days it would connect straight away.
Or connect when driving down the road.
Did you notice if yours connect straight away before installing the update ??
Q3 Can’t connect to Bluetooth in my car
Hello.
My Car : AUDI Q3 , 2014 , 4X4 , 2.0T
MULYIMEDIA : 8u0-035-183C
SOFTWARE VERSION : RMC_EU_P12321
I bought a firmware update
RMC_EU_K16158
For my multimedia from the site> upgrademyaudi.net
After a few minutes when I finish updating the firmware, I receive a message that the update was unsuccessful
I am attaching the video here for my Bluetooth issue
My phone can’t find Bluetooth
I also tried IPHONE ANDORID too
The problem is not on the phone
Can anyone help me (explain to me) how to solve the problem?
cosmicblue
Registered User
One doesn’t ‘buy’ firmware updates as they are supplied, electronically, by Audi in Germany to an Audi dealer. This isn’t a money-making scam but rather a reflection of the myriad of software inter-dependencies that each car has dependent on the options that were factory installed. You have most likely trashed MMI.
Stolen 27/6/2023 — 2020 RSQ3 Std, Daytona Grey
Gone, RSQ3 Performance, Ascari Blue
Gone, 2018 B9 RS4. Misano Red
Gone 2015 RSQ3, Sepang Blue
.
pronati
Registered User
One doesn’t ‘buy’ firmware updates as they are supplied, electronically, by Audi in Germany to an Audi dealer. This isn’t a money-making scam but rather a reflection of the myriad of software inter-dependencies that each car has dependent on the options that were factory installed. You have most likely trashed MMI.
OK
I think I will replace another MMI unit
To make the right choice
Would you recommend me to buy an MMI unit with the exact same part number? (8u0-035-183C)
I found on EBAY similar part numbers
Like: 8U0-035-183A
Which part number is best for my car?
R1 van
Registered User
I have just looked into this download as to update the software/firmware. (RMC_EU_P11474) TO (RMC_EU_K16158)
To try to fix the quality of the phone call as the person receiving the call cannot hear the person in the car. (microphone has been replaced)
I’ve been told that the software update could fix the fault ??
Also ours does the same sometimes with the bluetooth connection the same as in your video. But then on other days it would connect straight away.
Or connect when driving down the road.
Did you notice if yours connect straight away before installing the update ??
Spotify — Track Info on MMI over Bluetooth? (Android)
Very sorry if this has already been covered — I did try searching but couldn’t find anything.
I’ve recently got myself a ’13 A6 S-Line (All standard other than a couple of non-tech related options)
I’ve been listening to Spotify on my Android phone over the bluetooth connection. I can skip tracks using the car which is great, but I can’t see any information about what I’m playing on the screen. It just displays a message about the car being connected to the phone.
Is there any way this can be enabled?
MMI Software Version: RMC_EU_P12321
Bluetooth Software Version: 3.24.9
BahnStormer77
BahnStormer
Sounds like a good plan, I’ll confirm if this works with he latest software — I’m in the process of getting mine fully upgraded.
BahnStormer (aka LostBok)
A6 (C7) Avant 3.0TFSI SC remapped, DSG, rain and light sensor pack, LED headlight pac k, MMI touch, SDS high, AMI, 360deg sensors + auto-park, Stock 18″ rims w/ Dunlop SP Winter Sports / Pirelli P Zero’s.
voyto
Registered User
I had read in a few places that using a native app (like Goole Play Music) first would make the metadata kick in, but that doesn’t seem to work either.
BahnStormer77
BahnStormer
BahnStormer (aka LostBok)
A6 (C7) Avant 3.0TFSI SC remapped, DSG, rain and light sensor pack, LED headlight pac k, MMI touch, SDS high, AMI, 360deg sensors + auto-park, Stock 18″ rims w/ Dunlop SP Winter Sports / Pirelli P Zero’s.
BahnStormer77
BahnStormer
just to be clear, I can’t see the whole Spotify play list, just the details on the currently playing song: Song, Artist and Album info. If I skip track, the next track’s info comes up.
software version: 
result: 
and 
BahnStormer (aka LostBok)
A6 (C7) Avant 3.0TFSI SC remapped, DSG, rain and light sensor pack, LED headlight pac k, MMI touch, SDS high, AMI, 360deg sensors + auto-park, Stock 18″ rims w/ Dunlop SP Winter Sports / Pirelli P Zero’s.
BahnStormer77
BahnStormer
The only bit of the whole setup that might be different is that mine is running in Carphone mode.
I’m on an old Galaxy S4, but I’m running Cyanogenmod13 OS (AOSP based Marshmallow 6.0.1).
Samsung supports the carphone (SAP/RSAP Bluetooth mode) as stock, but to get that to work properly on CM13, I had to install «Android RSAP» software and «BTPB» (Bluetooth Phonebook) software from the same developer. as part of the install on that, you have to install «new» (old) Bluetooth drivers using the paired «SIM access Installer» software — only issue is that you need root access to run that installer.
Software all on PLAY, plus some info on which phones are supported on the «Android-RSAP» website.
BahnStormer (aka LostBok)
A6 (C7) Avant 3.0TFSI SC remapped, DSG, rain and light sensor pack, LED headlight pac k, MMI touch, SDS high, AMI, 360deg sensors + auto-park, Stock 18″ rims w/ Dunlop SP Winter Sports / Pirelli P Zero’s.